Solar Water Pump Controller Box - Mono Pond Aerator Series 3000 Sub-Sun SMC

Description

Solar Water Pump
Controller Box
- Mono Pond Aerator Series 3000 Sub-Sun SMC
Electrical
Series 3000 SMC
Voltage : 30 to 165 VDC
Current : 0 to 15 A
Power: 1500W Max.
Solar Array: 3000W Max.
Solar Motor Controller (SMC)
The SMC comprises a solar maximum power point tracker and brushless DC motor control electronics combined in the one enclosure. The MPPT converts adjusts the voltage on the solar array to maximize power generation and increases or reduces this voltage to suit the demands of the motor controller. The motor controller is an electronic commutator replacing the brushes in conventional DC motors. The motor controller senses back EMF voltages from the motor to determine the rotor position. This  information is fed into a micro computer to calculate the energizing sequence for the motor phases.
Features include:
• Input power ranges from 150 Watts to 2400 Watts from solar modules (refer to specifications for voltage, current and power limits for each SMC model.)
• Microprocessor controlled maximum power point tracking continuously changes the array voltage and
monitors the input power level thus following changes in the maximum power point of the array. This technology extracts the maximum available power form the solar modules.
•
• Remote On/Off control via float, pressure switch or water level control via probes placed in the bore hole.
• Electronic pressure cutoff system.
• Easily accessible On/Off switch.
• Interface to an optional Hand Held Display Unit
• Variable motor speed control via front panel or the optional Hand Held Display Unit.
• Thermal overload protection
• Input current overload protection detects if too many solar modules are connected to the SMC or if high currents are supplied from a battery source.
• Output current overload protection stops the system if the discharge pressure from the pump is too high.
• If the power output from the array is too low to start the pump, the system goes into “sleep” mode before
attempting to restart the pump. This reduces load on the circuits and heating of DC motors.
• Low motor speed cut off to reduce pump and motor wear.
• Float Switch Input Protection prevents damage if accessory devices connected to the float switch socked are wired incorrectly.
• Status lights to tell the operator what the system is doing.
3 Phase switched DC
Frequency: 0 to 100 Hz
Current : 0 to 9 A
Series 3000 SMC
Voltage : 30 to 165 VDC
Current : 0 to 15 A
Power: 1500W Max.
Solar Array: 3000W Max.